10/31/2022 0 Comments Aluratek usb to serial adapter driver![]() ![]() usb 1-2.2.5: new high-speed USB device number 26 using xhci_hcd r8152 1-2.1:1.0 (unnamed net_device) (uninitialized): Random ether addr 5e:fd:b7:b7:f9:bc usb 1-2.1: reset high-speed USB device number 24 using xhci_hcd Aluratek usb to serial adapter driver driver#usbcore: registered new interface driver cdc_ether usb 1-2.2: new high-speed USB device number 25 using xhci_hcd usb 1-2.1: new high-speed USB device number 24 using xhci_hcd Maybe the USB cable is bad?" to pop again and again? And is there anything else I can do?Ĭode: Select all usb 1-2: new high-speed USB device number 23 using xhci_hcd In the meantime can I just disable the part of the hub which causes the message "usb usb2-port2: Cannot enable. Aluratek usb to serial adapter driver how to#However I don't know how to submit bug report and also where to submit it. I think that the issue is somewhere in the kernel and is connected to the lack of hardware support for the HDMI. I have also tried 5.8 and also 5.12-mainline but the problem persists. r8152 1-2.1:1.0 eth0: carrier onĪnd after a few minutes my whole system freezes IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready usb 1-2.2.5: Manufacturer: VIA Labs, Inc. usb 1-2.2.5: Product: USB Billboard Device usb 1-2.2.5: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-2.2.5: new high-speed USB device number 9 using xhci_hcd usb 1-2.1: reset high-speed USB device number 7 using xhci_hcd usbcore: registered new interface driver r8152 usb 1-2.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-2.2: New USB device found, idVendor=272a, idProduct=0081, bcdDevice= 3.a3 usb 1-2.2: new high-speed USB device number 8 using xhci_hcd usb 1-2.1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-2.1: New USB device found, idVendor=0bda, idProduct=8152, bcdDevice=20.00 usb 1-2.1: new high-speed USB device number 7 using xhci_hcd usb 2-3: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 2-3: New USB device found, idVendor=272a, idProduct=0080, bcdDevice= 3.a3 usb 2-3: new SuperSpeed Gen 1 USB device number 2 using xhci_hcd ![]() usb 1-2: New USB device strings: Mfr=0, Product=1, SerialNumber=0 usb 1-2: New USB device found, idVendor=1a40, idProduct=0801, bcdDevice= 1.00 Code: Select all usb 1-2: new high-speed USB device number 6 using xhci_hcd ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |